The Brunel Engineering Two Sided Tape Applicator accepts up to 300mm diameter Tape Reels in widths typically between 12 and 24mm.
The machine can feed both Fingerlift and Edge-to-Edge Tape at linear speeds up to approx 40m/min.
User changeable standard guides are included for 12, 18, and 24mm tape widths. Other guide sizes available on request.
Tear tapes of 4mm width are best dealt with using the Bobbin version.
The machine uses a small motor to generate slack which enhances the Start / Stop position of the Tape and is controlled by its own logic relay device. An External Pattern Controller is required to be connected, which can have a control voltage of 3-32Vdc.
The machine can be supplied in full version, complete with Pattern controller, Encoder, Photocell and Tape machine.
Or as the Tape Machine only. This is useful for 2nd machines driven from the same Pattern Control System.
Two machines can be used side-by-side for twin tape lines, minimum distance between being approx 140mm. For access reasons, it is preferred to have twin machines mounted with one downstream of the other.
A transport (conveyor) is required, ideally a vacuum type. We would be pleased to quote you one of our own Vacuum Conveyors from our range.
The Tape Applicator operates at low voltage but requires a 230v plug-top supply
Shown in the photo above as 2-up and mounted on one of our own Vacuum Conveyors and in the video below, 3-up Tape Applicators processing Posters, again on one of our own Vacuum Conveyors
